V-TES can supply and install hazardous area electrical equipment which is accredited to worldwide standards (ATEX and IECEx), complete with full certification and a comprehensive level of technical support.

 We also offer Ex Inspection and register support. Our knowledge and experience of inspection, maintenance, RFID tagging, and Ex-area declassification will cut your workload and focus your efforts on your most hazardous areas.

V-TES specialise in cable Jointing and Terminations from LV up to and including 132kV on all types of cables.

Whether a straight splice or a motor termination, it’s essential that cable jointers are trained, competent, and familiar with your equipment.

V-TES offer (TDR) Time Domain Reflectometers - this is used for accurate cable fault detection and pre-location on HV/LV metallic & fibre optic cabling systems for Oil & Gas, wind farms, Telecommunications and on any cable network in any location. This form of cable testing is executed by transmitting an incident signal on to the cable and listening for the signal reflections.

V-Tes have an extensive track record of providing rope access support, working at height and access to difficult areas/equipment for onshore and offshore requirements.

We have Level 1 - Level 3 Technicians available for job scopes, to suit a variety of sectors.

Our Engineers can complete full harmonic surveys. This service can measures all the necessary voltage, current and power parameters for a full diagnosis of your electrical installation.

The survey will fully capture and record all of the parameters, transients, alarms and waveforms simultaneously, whilst taking all the power measurements needed to make an energy efficiency diagnosis.

Thermographic inspection surveys can be used as a tool for the early detection of problems across a wide range of industries and applications.

Regular inspection and analysis of IR data allows remedial actions to be taken before system failure.

Non-intrusive thermal surveys identify electrical faults and hot spots in switchboards and control panels such as overloaded circuits, faulty switchgear, and loose terminations.

Partial discharges (PD) are localised electrical discharges which only partially bridge the insulation between conductors and which can occur adjacent to a conductor.

PD occurs on high-voltage lines, in windings and other electrical equipment. PD can occur due to faults in windings caused by faulty enamelled wires, air pockets during casting, insulation faults or similar. Testing and analysis can be performed on both rotating equipment and switchboards

Switchgear requires regular surveys and maintenance. This would also include the extended protection Systems, Transformers, Battery Systems, and all associated cables.

V-TES has the equipment and knowledge in-house to make sure switchgear and related equipment support can be provided.

On or Off-shore services from Design through to Procurement, Installation, Commissioning, refurbishment and Health Care Contracts.

V-TES supplies highly trained and qualified Fibre Optic Specialist Engineers to the toughest of projects.

Our Engineers are capable of supporting all aspects of fibre installation: splicing, and testing, including the supply of fibre optic products and fusion splicers. Advanced Fibre Splicing can be incorporated in HV Cabling Jointing projects.